 |
Solutions |
 |
||||||||||||||
 |
|
Hardware Traffic Pro Hardware consists of the Event Logger and a range of Sensors (shown below) to provide the most robust people counting system on the market. Event Logger - 400 & 800, 410 & 810 (IP Ready)
The release of "IP Ready" Event Logger gives extra flexibility with data connectivity. You are able to plug the event logger into any LAN or WAN and transfer data directly over your current network structure (*Only with Enterprise Software). This minimises the need to run daisy chain cable between Event loggers. 400 Series
800 Series
Sensors
Beonic Thermal Sensors have the highest accuracy rate in its class with accuracy levels consistently above 90% without the need for any multipliers or dividers. The sensor will maintain this accuracy even in very hight flow rates such as Train Stations, Airports, or shopping centre entries. Beonic Thermal Sensors are ceiling mounted they see all of the people passing under the sensors. Traditional side mounted technology is unable to separate people entering in groups or in high flow environments. Beonic Thermal Sensors are not affected by ambient lighting conditions or shadowing, which is a common complaint of video based people counting solutions. Beonic Thermal Sensors are available in two types:
The width the Beonic Thermal Sensors will see is dependent on the height of the area to be counted. The lower the height, the narrower the width. Beonic Thermal sensors come in three lens angles to let count at heights up to 12.5m above the floor. Overhead* sensor benefits *Overhead sensors are thermal or video Overhead versus beams
Thermal versus video
|
||||||||||||
Beonic supports various types of sensors for all types of doorways and zones. The sensors are either designed, manufactured or tested at Beonic and we know from experience that the sensors we stock are accurate, reliable and robust. The selection of sensors available will cover most types of doors and entry points. We can supply sensors that can perform reflex, through-beam, bi-directional, proximity and thermal counting. Various face plates for the sensors are available to give a professional finish and a non-obtrusive look. The New Thermal Sensor (shown to the right) is installed in the ceiling overhead which removes the ablility to block the sensor and has proven to provide the most accurate form of peolple counting in the world today.
The ceiling mounted sensors use an Active Infra-Red (IR) system to detect the heat of people passing underneath the sensor. The sensors see a square on the floor approximately the same size as the height of the unit. They track all movement of body heat through this space. The sensors have a flexible counting zone that can be easily changed to maximise the counting accuracy of the entry.
